USG Shaft & Stair Wall Systems are generally constructed with the following components. 550 West Adams Street Chicago, IL 60661 For attachment to steel framed construction install floor and ceiling J-runners and End wall J-Runners or E-Studs, on columns and beams before the steel is fireproofed, except where Z-Clips are used as in UL Design HW

2022. 2. 2. · Installation Instructions The Area Separation Wall is constructed once the framing for one townhouse unit is complete and prior to the construction of the adjacent unit. The solid 2” (51 mm) Area Separation Wall is constructed a minimum 3/4” (19 mm) away from the adjacent framing, which is typically constructed from wood.

3 USG Shaft Wall Systems User's Guide This brochure explains: - What a shaft wall system comprises section of shaft wall is needed for a single vertical pipe make it difficult to install shaft liner panels and studs penetration. The solid shaft is structurally limited to a vertically. This is true for walls separating shafts when there

USG shaft wall systems are non-loadbearing gypsum wall partition assemblies constructed from outside the shaft at each floor. Shafts are enclosed early in construction, and the walls are finished later, along with interior partitions. Installation is quick and easy, using components and application procedures familiar to drywall contractors.

USG Cavity Shaft Wall Systems have been designed and tested using accepted engineering practices with deflection criteria of L/120, L/240 and L/360 clear partition heights. They are covered by three model building codes under NER 258. USG Cavity Shaft Wall Systems are approved under NER 258 for horizontal applications to

For Fire Resistance details and construction methods, refer to UL Design #U415 System A and the USG installation instructions. Two-Hour Cavity Shaft Wall (Non- 

Environmental Limitations: Comply with gypsum-shaftliner-board manufacturer's written instructions. Do not install finish panels until installation areas are 

2013. 2. 28. · USG Shaft Wall Systems

Gyprock Shaft Systems are non-loadbearing, fire resistant wall assemblies designed to encase lift shafts, stairwells and service ducting in low and high rise construction. Gyprock Shaft Systems combine lightweight construction, rapid installation and plasterboard finishing techniques to offer significant cost savings to builders and developers particularly when combined with structural

United States Gypsum Company USG, Gypsum Board Shaft Wall Systems. CSI 3-Part Specifications., 3-Part and installation instructions for systems used.

4 USG Shaft Wall Systems Overview USG shaft wall systems are non-loadbearing gypsum wall partition assemblies constructed from outside the shaft at each floor. Shafts are enclosed early in construction, and the walls are finished later, along with interior partitions. Installation is quick and easy, using components

SCAFCO has engineered and designed the I-Stud Shaftwall Fire ratings, installation instructions, and CAD detail assemblies available at SCAFCO.com.

Technical Support 1-800-USG-4YOU Product Safety Hotline 1-800-507-8899 Product Categories

Install C-H Studs horizontally with the open “C” section of the studs facing down, and spaced 24'' on center. 22 USG Shaft Wall Systems. 23 USG 

USG Cavity Shaft Wall Systems Catalog - SA926; USG Acoustical Assemblies Brochure (English) - SA200; USG Area Separation Wall Systems Brochure - SA925; Plaster Systems Brochure - SA920; Gypsum Association Fire Resistance Design Manual (GA600)

USG shaft wall systems are non-loadbearing gypsum wall partition assemblies constructed from outside the shaft at each floor. Shafts are enclosed early in construction, and the walls are finished later, along with interior partitions. Installation is quick and easy, using components and application procedures familiar to drywall contractors.